C175-16 Generator Set
360° Exterior View
At a Glance
|
|
|
|
|
|
|
|
Overview
Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.
Generator Set Specifications
+ -| Standby Rating | 3365(no fan)/3250/3100(no fan)/3000 ekW |
| Prime Power Rating | 3115(no fan)/3000/2825(no fan)/2725 ekW |
| Emissions/Fuel Strategy | Low Fuel, Tier 2 |
| Voltage | 480 to 13800 Volts |
| Frequency | 60 Hz |
| Speed | 1800 RPM |
| Duty Cycle | Standby, Mission Critical, Prime, Continuous |
| Maximum Rating | 3365 ekW |
| Minimum Rating | 2500 ekW |
Engine Specifications
+ -| Engine Model | C175-16 SCAC, V-16, 4-Stroke Water-Cooled Diesel |
| Bore | 6.89in |
| Stroke | 8.66in |
| Displacement | 6456.31in³ |
| Compression Ratio | 16.7:1 |
| Aspiration | Turbo Aftercooled |
| Fuel System | Common Rail |
| Governor Type | ADEM� A4 |
Generator Set Dimensions
+ -| Length - Minimum | 241.6in |
| Length - Maximum | 312.9in |
| Width - Minimum | 83.1in |
| Width - Maximum | 113.7in |
| Height - Minimum | 87in |
| Height - Maximum | 134.3in |
| Dry Weight - Genset (minimum) | 42750lb |
| Dry Weight - Genset (maximum) | 50500lb |
Standard Equipment:
Air Inlet System
+ --
4 x Single element canister with service indicator(s).
Control Panel
+ --
2 Programmable relay outputs (Form C)
-
Low coolant level
-
Over/under voltage
-
Coolant temperature
-
Serial annunciator module data link
-
Alarm acknowledge
-
Text alarm/event descriptions
-
Volts (L-L & L-N)
-
Reverse power
-
Over/under frequency
-
Environmental sealed front face
-
Programmable protective relaying functions
-
Speed adjust
-
Generator phase sequence
-
Low coolant temperature
-
Generator mounted - rear facing
-
Overspeed
-
Controls
-
Frequency (Hz)
-
Engine cycle crank
-
Engine cool-down timer
-
Warning/shutdown Indicators:
-
Lamp test
-
2 Programmable digital outputs
-
6 Programmable digital inputs
-
High coolant temperature
-
Customer data link (Modbus RTU)
-
Auto/start/stop control
-
Emergency stop pushbutton
-
RPM
-
Digital Indicators
-
Communications
-
Accessory module data link
-
Oil pressure (psi, kPa or bar)
-
Low oil pressure
-
Overcurrent
-
Emergency stop
-
24 Volt DC operation
-
4 Programmable relay outputs (Form A)
-
Failure to start (overcrank)
-
True RMS AC metering, 3-phase, +/-2% accuracy
-
Power factor (per phase & average)
-
Operating hours
-
DC volts
-
Amps (per phase & average)
-
EMCP 4.2B
-
Reverse reactive power
Exhaust System
+ --
Bolted flange, with bellow for each turbo
-
Exhaust flange outlet
Fuel System
+ --
Engine mounted filters #REF!
-
Filters x 3
-
10 Micron spin on yype
-
Secondary/tertiary fuel filters
-
4 Micron spin on type
-
Primary fuel filter water/fuel water separator
Generators And Attachments
+ --
Right side extension box, bottom cable entry
-
IEC platinum stator RTDs
-
Reactive droop capability
-
3 Phase voltage sensing
-
(MV) Busbar connections, right side extension box, bottom cable entry
-
Class F temperature rise at 40C ambient
-
Anti-condensation space heater
-
NEMA Class H insulation
-
6 Leads
-
Class H temperature rise at 40C ambient
-
Voltage regulator
-
Exciter diode monitor
-
Form wound
-
RFI suppression
-
(LV) Busbar connections, top/center mounted, top cable entry
-
3 Phase brushless
-
60 Hz models: NEMA standard hole pattern
-
Permanent magnet excitation (PMG)
-
Min / max exciter limiter
-
Salient pole
Governing System
+ --
Redundant shutdown (Overspeed protection through a duplicate speed sensing system)
-
ADEM A4
Lube System
+ --
Oil filter, filler and dipstick
-
Integral lube Oil cooler
-
Oil drain lines and valve
-
Fumes disposal
-
Lubricating oil
-
Prelube - required with prime, continuous, and standby
-
Gear type lube oil pump
Mounting Systems
+ --
Rails - Engine/generator
-
Rubber anti-vibration mounts - shipped loose
-
Dual 24 volt electric starting motors
-
Battery disconnect switch
-
Batteries and battery rack w/cables
Power Termination
+ --
Busbar
Service Instructions
+ --
Two PM inspections
General
+ --
Paint - Caterpillar yellow with high gloss black rails & radiator
-
SAE standard rotation
-
LH Service
-
Flywheel and flywheel housing-SAE No. 00
Optional Equipment:
Air Inlet System
+ -Air inlet adapters
Dual element air cleaner
Single element air cleaner
Air inlet protection
Control Panel
+ -Package mounted radiator
Automatically selected ground
Customer AC-DC connection mounting location - LV/MV
Load share governor
EMCP 4.3, EMCP 4.4
E-Stop
Frame boxes
Annunciator modules
Load share module / auxiliary plate and auxiliary box (LV)
Fuel cooler
EMCP mounting location - LV/MV
Modbus monitoring of packages
Customer interface options
EMCP 4.4 optional harness
EMCP voltage and current sensing groups
Remote radiators
Generator harness
Interconnect harness
Speed adjust
EMCP and MV and HV power connection locations
Raise lower switch
Crankcase Systems
+ -Explosive relief valves
Crankcase ventilation system
Exhaust System
+ -Mufflers
Exhaust support group
Weld flanges
Exhaust collectors/manifold
Front housing - Prime or continuous
Front housing - Standby or mission critical
Aftercooler drain
Fuel System
+ -Primary fuel filter
Generators And Attachments
+ -Low voltage - 1800 and 3000 Frames - 60 Hz, 3 phase, 1800 rpm, FW, PM, No of leads=6, Pitch 0.6667
Medium voltage - 1800 and 3000 Frames - 60 Hz, 3 phase, 1800 rpm, FW, PM, No of leads=6, Pitch 0.6667
Conversion GP - Top cable entry
Low voltage - 1800 and 3000 Frames - 50 Hz, 3 phase, 1500 rpm, FW, PM, No of leads=6, Pitch 0.6667
Differential current transformers
Space heater kit
Medium voltage - 1800 and 3000 Frames - 50 Hz, 3 phase, 1500 rpm, FW, PM, No of leads=6, Pitch 0.6667
Thermostat for space heater
Generator air intake
Instrumentation
+ -Pyrometer and thermocouples
Lube System
+ -Drain group oil pans
Oil filters
Lube oil heater
Electric prelube pumps
Lubricating oil
Mounting Systems
+ -IBC vibration isolators - Shipped loose
Spring type linear vibration isolators
Rubber anti-vibration mounts
Power Connections
+ -Low voltage connection cable
Center post busbarss (LV)
1800 Frame generator side / rear mounted busbars (MV)
Enclosures - Control packaging (LV)
Paralleling circuit breakers
1800 Frame generators Circuit breaker
Neutral ground (LV)
Neutral ground (MV)
Cable entry options (LV)
Cable entry options (MV)
Masterpack breakers
Power connection covers (LV)
Harnesses (Breaker)
Masterpack breaker connections
Side/rear mounted busbars (LV)
Special Tests / Reports
+ -IBC seismic Certification
Special test charge - Engine only
PGS Test report @ 0.8 power factor
Genset fuel consumption test
Standard genset TVA (Torsional Vibration Analysis) report
PGS Test report @ 1.0 power factor
OSCOSH1 seismic Certification
Custom generator TVA report
Generator test report
Standard engine test charge
Starting / Charging System
+ -Heavy duty battery sets with rack
Charging alternators - Dry
Air pressure regulator
Starter location covers
24 Volt power distribution box
24 Volt electric starting motor
35 Amp Battery chargers
24 Volt battery set - Dry
20 Amp Battery chargers
Jacket water heaters
50 Amp Battery chargers
Air starting motor
Jacket water heater wiring groups
General
+ -Special paint colors
Control GP - air powered bar group
Barring group manual
Service tools - Engine barring group
Engine barring air powered